How to run:

Directions for use on a horizontal surface: apply the substrate in a separate execution step with a sufficient amount of material and let the substrate remain wet for at least 2 to 3 minutes before penetrating the surface. Sweep the pores until it penetrates the surface. Repeat another coating. The coated surface should feel dry to the touch after about an hour. The coated surface must be protected from air erosion for at least 8 hours after application. A neutral pH surface may require several days to fully seal. Instructions for use on a vertical surface: For better results, apply SurfSeal SB wet-wet (applying the second layer before the first layer dries) on an absorbent and dry surface. When using a sprinkler container, fill it with enough material so that the liquid level is 10 to 20 cm below the catch point. Let the liquid penetrate under the work for at least 5 to 10 minutes during the first spraying, then repeat spraying again. If using a brush or roller, evenly coat the surface and allow SurfSeal SB to penetrate the surface for 5 to 10 minutes. Leaving a lot of brush marks and dripping from it shows that the penetration has stopped. Repeat again. Clean tools, equipment, and any surfaces or objects that are contaminated with sprayed particles with xylene or soap and warm water. Surfaces to be coated with SurfSeal may be coated with silicone solvent paints and many oil based paints, so it is always necessary to test the product before application to ensure adhesion. The adhesion of this product on coatings with cement materials or with cement properties (plaster and cement mortar, cement mortar, etc.) may decrease. The procedure for this type of surface is that it must be cemented and allowed to set completely before applying SurfSeal. Please note: it is always necessary to do a small test on a partial surface (on the same concrete surface) to get the desired result before use.