PM Megapoxy – Negin Tejarat Ferdos

Megapox PM
Category: Megapox glue
Description

Megapox PM

This paste-like material with a working time of 45 minutes and high strength is used to install all kinds of stones and joints. Megapoxy glue has a two-component structure and is based on epoxy. When this pasty material is properly set, it turns into a solid material that is resistant to other chemicals and due to its very high strength, it creates a permanent chemical bond that does not undergo any change over time. It is not chemical. This glue, while flexible, is resistant to pressure and still maintains its strength.

Megapox glue consists of two main components:
Website design in Karaj
1. Epoxy resin: Epoxy resin or EP (Epoxy) is a resin that is used as the main ingredient in the composition of mega-epoxy glue. This resin is highly resistant to bending, pressure and heat. Also, epoxy resin is resistant to chemicals and moisture.

2. Additives: Megapoxy adhesive may contain other additives designed to improve its properties, such as heat resistance, increased adhesion, delayed setting time, and longer shelf life.

Technical information

Megapox PM
Epoxy ester brand: Megapoxy
Color: white
Mixing ratio: 1 to 1
Working time: 45 minutes
Minimum holding time at 25: 4 to 6 hours
Complete capture: 24 hours
Tensile strength: 25 Mpa
Shear tensile strength: 10 Mpa
Compressive strength: 80 Mpa
Bending strength: 15 Mpa
Country of manufacture: Australia

How to run:

In order to use PM correctly, this material should be used in the four corners and center of the desired surface, and in general, about 10% of the desired surface space is covered by this material.

In order to implement, we first mix the two components A and B of the desired glue equally, and put the necessary amount on the stone or concrete or metal form in five points. If it is not mixed completely and correctly, it will not have the necessary efficiency and will lose its complete adhesion and will always remain in the form of paste.

سلام